To get that satisfying thunk when a door closes rather than rattles squeaks or scrapes there must be an even gap between the door and the jamb all around.
Attic door not flush.
I have a set of pull down attic stairs that work great except that when they are in the closed position there is an opening of about an inch to and an inch and a half.
There are however problems that could arise with attic stairs.
Best access doors suggests installing the ceiling access door flush installation.
When you close the door the lipstick transfers to show if the latch is hitting the strike plate too high too low or just right.
Because of this a set of pull down attic stairs is the best way to reach the attic.
I would like to determine what i need to adjust or fix to have them flush with the ceiling when they are closed.
Don t overestimate how much you need to take off.
You will need to cut the bottom of the door.
The hinges should be flush with the jamb and move freely.
M y ladder won t stay up in the attic.
And the stop and the strike plate should be correctly aligned so the door s latch easily clicks into the hole in the strike plate when the door closes.
The springs connect to power arms at the upper end of the stairs and keep the door closed and even with the ceiling.
We have a service outline that is open for all your calls inquiries anytime.
E z hatch attic access door r 50 alternative to attic stair ladder 3 2 out of 5 stars 3 panady attic stairs insulation cover 25 x 54 x 11 class a fireproof attic door insulation cover attic access insulation cover attic stairway insulator attic ladder insulation cover.
Measure down from the bottom hinge to determine how much you need to trim.
If the door rubs for too long on the carpet it can cause the fibers to break down and leave a permanent swing mark.
How to fix and trim a rubbing door.
Check where the latch on the door hits the strike plate on the frame.
Pull down attic stairs have coil springs at each side of the unit.
When the arm is mounted to the attic floor the arm should be pointing away from the ladder and opening.
The family handyman suggests covering the strike plate with masking tape and smearing lipstick on the latch.
When it comes to ceiling and attic installations you need an access door that will not interfere with the surface design or finish.
Mos t likely the assist arm is oriented the wrong way.
When built correctly the stairs are concealed within the attic itself.
It is an assist pole to help with opening and closing the ladder and also with opening and closing the door.